With boat owners in mind, this worldwide voltage adaptive 5-step Phoenix 1+1 50A Battery Charger model provides 3-4A to the starter battery, and the rest to the ‘house’ bank. With Bluetooth enabled, you can monitor the charger and set alarms straight from your phone.

Adaptive, intelligent, dynamic charge features:

Bluetooth Smart built-in

The wireless solution to set up, monitor, update and synchronise Phoenix Smart IP43 Chargers.

Phoenix Smart (1+1): two outputs to charge 2 battery banks

The second output, limited to approximately 4A and with a slightly lower output voltage, is intended to top up a starter battery.

Automatic voltage compensation

The charger compensates for voltage drop over the DC cabling by slightly increasing output voltage when the DC current increases. Please see the manual for details.

Adaptive 6-stage charge algorithm: bulk– absorption – recondition – float – storage – refresh

The Phoenix Smart Charger features our well-known ‘adaptive’ battery management system that can be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimise the charging process relative to the way the battery is being used.

The right amount of charge: variable absorption time

When only shallow discharges occur (a yacht connected to shore power for example) the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery will be fully charged.

Preventing damage due to excessive gassing: the BatterySafe mode (see fig. 2)

If, in order to quickly charge a battery, a high charge current in combination with a high absorption voltage has been chosen, the charger will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached (see the charge curve between 14,4 V and 15,0V in fig. 2).

Less maintenance and aging when the battery is not in use: the Storage Mode (see fig. 1 & 2)

The Storage Mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the Storage Mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.

Charge curves: up to the gassing voltage and exceeding the gassing voltage

Also charges Li-ion (LiFePO₄) batteries

Charger on-off control can be implemented by connecting a relay or open collector optocoupler output from a Li-ion BMS to the remote on-off port.
Alternatively, full control of voltage and current can be achieved with Bluetooth.

Fully programmable charge algorithm

The charge algorithm can be programmed with help of Bluetooth or the VE.Direct interface. Three pre-programmed algorithms can be selected with the mode button.

Optional external battery voltage and temperature sensing via Bluetooth

A Smart Battery Sense or a BMV-712 Smart Battery Monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 Chargers.

Remote on-off

The remote on/off consists of two terminals: Remote H and Remote L. A remote on/off switch or relay contact can be connected between H and L.
Alternatively, terminal H can be pulled high, or terminal L can be pulled low.

VE.Direct interface

For a wired data connection to a Colour Control panel, PC or other devices.

Programmable relay

Can be programmed using the VE.Direct interface or a Bluetooth-enabled device to trip on an alarm or other events.

Synchronized charging

Pairing two or more Phoenix Smart IP43 Chargers in a VE.Smart Network, enables synchronised charging. This improves the charge efficiency and battery life.

Phoenix Smart IP43 Charger 12/30
(1+1) & (3)
12/50
(1+1) & (3)
24/16
(1+1) & (3)
24/25
(1+1) & (3)
Input voltage 85 - 250VAC (full power from 100VAC, startup from 90VAC)
DC input voltage range 290 – 375 VDC
Frequency 45-65 Hz
Power factor 1
Back current drain <1mA
No load power consumption 1 W
Maximum Efficiency 95% 94% 96% 96%
Charge voltage - Absorption / Float / Storage Normal: 14.4V / 13.8V / 13.2V High: 14.7V / 13.8V / 13.2V
Li-ion: 14.2V / N/A / 13.5V
Normal: 28.8V / 27.6V / 26.4V High: 29.4V / 27.6V / 26.4V
Li-ion: 28.4V / N/A / 27.0V
Fully programmable Yes, with Bluetooth and/or VE.Direct
Maximum input current setting 3 – 10A
Number of battery connections (1+1) models: 2 (2nd output via 2 pole terminal & 4A max) | (3) models: 3
Charge current house battery 30 A 50 A 16 A 25 A
Low current mode 15 A 25 A 8 A 12,5 A
Temperature compensation - Default -16mV/°C -32mV/°C
Charge current starter battery 4 A Max (1+1 output models only)
Charge algorithm 6-stage adaptive (3 stage for Li-ion)
Protection Battery reverse polarity (fuse, not user accessible) / Output short circuit / Over temperature
Can be used as power supply Yes, output voltage can be set with Bluetooth and/or VE.Direct
Operating temp. range -20 to 60°C (0 - 140°F)
Rated output current up to 40°C, derate linearly to 20% at 60°C
Humidity (non-condensing) max 95%
Remote on/off Yes (2 pole terminal)
Relay (programmable) Yes (SPDT - 5A up to 250VAC / 5A up to 28VDC)
Bluetooth Power: -4dBm | Frequency: 2402 - 2480MHz
ENCLOSURE
Material & Color aluminium (blue RAL 5012)
Battery connection Screw terminals 16 mm² (AWG6)
AC-connection IEC 320 C14 inlet with retainer clip (AC cord ordered separately)
Protection category Electronic components: IP43 | Connection area: IP22
Weight kg (lbs) 2,7 kg (6 lbs)
Dimensions (h x w x d) 180 x 249 x 116 mm (7.1 x 9.8 x 4.6 inch)
STANDARDS
Safety EN 60335-1, EN 60335-2-29
Emission EN 55014-1, EN 61000-6-3, EN 61000-3-2
SKU VIC.PSC125051095
Model # PSC125051095
UPC/EAN 8719076053507
Brand Victron Energy
Shipping Weight 4.0000kg
Shipping Width 0.150m
Shipping Height 0.250m
Shipping Length 0.280m
Shipping Cubic 0.010500000m3

Purchase with confidence knowing your product is covered by the Victron 5-year manufacturer warranty.

Be The First To Review This Product!

Help other Outback Marine Australia Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review